Economical LNB Band Products – Where Can I Procure Them?

by

Todd Ewing

Here\’s The Best Way To Set Up All LNB, LNB F and a Satellite Dish System

Use a spirit level so you can be certain that the dish mast is vertically level on all the required angles. If you fail to, it will make it harder for you to locate the sat dish so that you obtain a good sat signal. When it is plumb, firm up the bolts.

3. Mount your satellite dish upon the sat dish mast.

Nip up the fixings but only enough to take any slack out of the dish. Obtain your coordinates which are obtained at the receiver initial setup procedure in regards to your area code and then adjust your azimuth, dish elevation and the skew as needed. Make use of a compass pointer to obtain your best estimate as far as azimuth. Do not fully tighten the bolts right at the moment; leave bolts a little slack so that you can easily adjust them when you fine tune the sat signal.

4. Plug a sat signal locator onto the LNB connection from the sat dish receiver.

In the event you haven\’t got a signal finder meter they can be brought from LNBShop.info, via the internet for as little as $20 for a cheap one. You can also utilize your sat receiver combined with a TV for your signal finder meter simply by selecting the view signal strength indicator preference at the time of a setup procedure with your sat receiver. The person doing this will likely need some help to fiddle with the dish deploying this strategy. Be sure to use the default 101 orbital location and transponder 1, if you are DirecTV members following that Select MENU, then choose option 6, choose option 1, choose option 1 on your remote for Dish Network.

Get your sat finer and turn its db strength up or down to just find an audible tv signal tone then sweep the southern sky so that you get a fair idea of the satellite location points. Usually you should find 5 or so satellite bearings after a sat scan. In the event you do not find any or get only 1 to 2 satellites, recalibrate the angle till you zero in on further satellites.

For people who have an antenna from DirecTV, start at bearing East then seek the one hundred and one degrees sat location. It\’s usually 2nd away from East. First is most likely in a 98 orbit point that is normally minor as well as fainter in the event the elevation is honed true.

For people who have the Dish Network antenna, commence from West bearing and hone in to the 119 sat location. It is usually second from West. 1st is most likely in a 129 degree orbit position which is usually barely audible and more faint if the dish elevation is positioned correctly.

Alter meter\’s db noise levels further down to allow you to finely hone your signal. Once you have the strongest available signal by adjusting it\’s azimuth, firm up it\’s bolts just enough that it holds the satellite dish from pivoting. Visit the link below to read the total article regarding the best way to fit any lnb, ku lnb as well as a dish arrangement

The LNBShop is an authorized Reseller of WSI Products International Satellite tv Tools including Accessory Supplies for pros and also the do it yourself dish fixers.

The LNB Shop range of stock incorporates LNB, LNBF, LNBs, hd lnb, dual lnb, quad lnb, quattro lnb, c lnb, ku lnb, lnb brackets and accessories, satellite tv for pc dish and dish accessories, satellite finder meters, satellite television meters, birdog sat meters fta sat and dish receivers as well as everything you need fo

Article Source:

ArticleRich.com